Hunter Fan 40170 - Manual (Page 15)

1
2. Position the new thermostat on the wall and pull the
labeled wires through the opening.
3. If the existing holes do not match those on the Hunter
wall plate, or if there are no existing holes, level the
thermostat and mark the wall for two holes.
4. Remove the thermostat and drill two 3/16” holes where
marked.
5. Tap the plastic anchors into the holes until they are flush
with the wall.
6. Reposition the thermostat on the wall, pulling the
wires through the opening. Insert the mounting screws
through the mounting holes and into the anchors. Verify
that the thermostat is visually level and securely tighten
both screws.
installing the thermostat, cont.
INSTALLING THE WALL PLATE