Hearth and Home Technologies CB1200-B - Manual (Page 4)

Page 4 7014-082D September 1, 2008
R CB 1200 Pellet Stove
1
Listing and Code Approvals
A. Appliance Certification
C. Glass Specifications
E. BTU & Efficiency Specifications
This appliance is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided. The structural integrity of
the mobile home floor, ceiling, and walls must be maintained.
The appliance must be properly grounded to the frame of
the mobile home and use only Listed pellet vent Class “L”
or “PL” connector pipe. A Quadra-Fire Outside Air Kit must
be installed in a mobile home installation.
B. Mobile Home Approved
NOTE: This installation must conform with local codes. In
the absence of local codes you must comply with the ASTM
E1509, ULC S627-M93, ULC/ORD-C-1482-M1990, (UM)
84-HUD
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
*BTU output will vary, depending on the brand of fuel you
use in your stove. Consult your Quadra-Fire dealer for
best results.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifications and/or price without notice.
Emissions Rating 0.
.
9 grams/hr
*BTU Output 14,000 - 40,000 / hr
Heating Capacity up to 2,500 sq. ft. depending
on climate zone
Hopper Capacity 80 lbs
Fuel Wood Pellets or Shelled Corn
Shipping Weight 349 lbs
Model CB1200 Pellet Stove
Laboratory OMNI Test Laboratories, Inc.
Report No. 061-S-21-4
Type Solid Fuel Room Heater/Pellet Fuel
BurningType
Standard ASTM E1509-95, ULC S627-M93 and
ULC/ORD-C1482-M1990 Room Heater
Pellet Fuel Burning type and (UM) 84-
HUD, Mobile Home Approved.
State Listing Colorado, Listed 09-13-05