HotBrick Dual WAN Firewall VPN 1400/2 - Manual (Page 30)

HotBrick, Tel: 305-398-0888, Fax: 305-398-5966
Advanced configuration – virtual server
Virtual Server Configuration
 Enable – The enable checkbox enables or disables each Virtual server as required.
 Server Name – Enter a name for this server. (By default, there are 12 well-known
virtual servers on the Custom Virtual Server List that you may use.)
 Protocol – Select the network protocol (TCP/UDP) used by this sever.
 IP Address – LAN, Enter the IP address of the server on your LAN which is running the
required Server software.
Each Host (server) should have a fixed IP address, or a reserved IP address. (See the
Host IP section earlier in this Chapter for details on reserving an IP address.)
Each Host (server) must be running the appropriate Server software
 WAN – This selection allows this server to bind to any selected WAN port, or to bind all WAN
ports together.
 LAN Port Range – Enter the range of port numbers used for outgoing traffic from this
Server. If only a single port is required, enter it in both fields.
 WAN Port Range -– Enter the range of port number used for incoming traffic to this Server.
If only a single port is required, enter it in both fields
 Allowed Remote IP – This allows only a range of remote side IP address to access the virtual
servers. The default is 0.0.0.0 ~ 0.0.0.0, means all remote side IP address can access it.
Buttons
 Add – Create a new Virtual Server entry.
 Delete – Delete the selected entry.
30