HotBrick Dual WAN Firewall VPN 1400/2 User Manual

Page 25

HotBrick, Tel: 305-398-0888, Fax: 305-398-5966

Reserve in DHCP – Select Enable to reserve a particular (LAN) IP address for a

particular PC on your LAN. This allows the PC to use DHCP (Windows calls this
"obtain an IP address automatically") while having an IP address that never

changes.

Reserved IP Address – Enter the IP address you wish to reserve, if the setting

above is Enable. Otherwise, ignore this field.

Host Network Binding

Binding WAN Port / Session – Select Enable if you wish to associate this PC with

a particular PPPoE session. All traffic for that PC will then use the selected PPPoE

port and session.

Binding Method – Suppose your PC is bound to WAN1 port, now you are selecting

“Strict Binding”. If WAN1 port is disconnected, your packets cannot go out through
the other WAN port, if it is still alive. If you select “Loose Binding” then when the

WAN1 port is disconnected, your packets will automatically go to the other WAN port, if
it is active.

Select WAN Port / Select PPPoE session – If the setting above is Enable, select

the desired Port and Session. Otherwise, ignore these settings.

Note: Multiple PPPoE sessions are defined on the Advanced PPPoE screen.

Buttons

Add – Use this to add a new entry to the database, using the data shown on

screen.

Delete – Click this to delete the selected entry.
Update – Use this to update the selected entry, after making the desired changes.
Reset – Reset changes you have made since loading the data from the

Multi-WAN VPN Load Balancer.

Host & Group list – This table shows the current binding.