Saw chain filing and file gauges, Technical data – Husqvarna 575XP User Manual
Page 39
English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for Husqvarna chain saw models 575XP AutoTune. These chain saw
models equipped with either of the listed bar and sawchain combinations, fulfills the requirements according to ANSI B 175.1-
2000 (Gasoline Powered Chain Saws - Safety Requirements).
Note: ATM (Armour Tip Medium) is a designation for a hard nose bar with nose radius 1,33”.
Saw chain filing and file gauges
Bar
Chain
Length, inch
Pitch, inch
Gauge, inch
Max. nose radius
Type
Drive link count
16
3/8
0,058
11T or ATM 1,33”
Husqvarna H42,
Husqvarna H48
60
18
3/8
0,058
68
20
3/8
0,058
72
24
3/8
0,058
84
28
3/8
0,058
92
32
3/8
0,058
105
16
3/8
0,050
11T or ATM 1,33”
Husqvarna H46,
Husqvarna H47,
Husqvarna H47S,
Husqvarna H82
60
18
3/8
0,050
68
20
3/8
0,050
72
24
3/8
0,050
84
28
3/8
0,050
93
32
3/8
0,050
105
!
WARNING! This chain saw is capable of
severe kickback that could result in serious
injury to the user. Do not operate this chain
saw unless you have extraordinary cutting
needs and experience and specialized
training for dealing with kickback. Chain
saws with significantly reduced kickback
potential are available.