HP Monitor LE1901wm - Manual (Page 25)

Icon Main Menu Submenu Description
Video Input
Control (select
models) Selects the video input signal. DVI is the factory
default.
Switch Video Input Selects the other (VGA or DVI) video input signal.
Default is DVI.
Auto-Switch Input Turns the system's automatic video signal input to on
or off. The factory default is On.
Default Video Input Selects the default or primary video input signal when
the monitor is connected to two active and valid video
sources. The monitor will automatically determine the
video format. The default input selection is DVI.
Analog — VGA — Selects VGA input.
Digital — DVI — Selects DVI input.
Information Selects and displays important information about the
monitor.
Current Settings Provides the current input video mode.
Recommended
Settings Provides the recommended resolution mode and
refresh rate for the monitor.
Serial Number Reports the serial number of the monitor. The serial
number is needed if contacting HP technical support.
Version Reports the firmware version of the monitor.
Backlight Hours Reports the total hours of backlight operation.
Service Support: http://
www.hp.com/support
Factory Reset Returns all OSD menu settings and DDC/CI controls
to the factory default settings, except the Language.
Exit Exits the OSD menu screen.
Table 4-2 OSD Menu (continued)
ENWW Adjusting the Monitor Settings 19