beautypg.com

Instrument panel brightness, hazard warning button – HONDA 2009 Element User Manual

Page 79

background image

The level of brightness is shown on
the information display while you
adjust it. It goes out about 5 seconds
after you finish adjusting.

To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to

or

. Turning the select/reset

knob to the right until you hear a
beep will cancel the reduced
brightness.

The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver's door.
The brightness will increase slightly
when you insert the key in the
ignition switch, then go to normal
brightness when you turn the
ignition switch to the ON (II)
position.

If you do not insert the key in the
ignition switch after opening the
driver's door, the illumination turns
off about 30 seconds after you close
the door.

If you insert the key but do not turn
the ignition switch to the ON (II)
position, the illumination turns off in
about 10 seconds.

Hazard Warning Button

Push the button next to the shift
lever to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both turn indicators in the
instrument panel to flash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traffic, or if your vehicle is disabled.

BRIGHTNESS LEVEL

U.S. model is shown.

Instrument Panel Brightness, Hazard Warning Button

73

Instruments

and

Controls