Harbor Freight Tools ONE STOP GARDENS 95690 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. Item 95690/95692
Operating instructions
Read the EntiRE impORtant SaFEtY inFORmatiOn section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
inspect Sprayer before use, looking for damaged, loose, and missing parts.
if any problems are found, do not use Sprayer until repaired.
Follow all guidelines regarding chemicals sprayed, including mSDS instructions and Epa regulations.
Release pressure in tank by pulling up on the pressure Release Valve before loosening
or removing parts. Contents are under pressure and may spurt forcefully.
1. Before filling, pull up on Pressure Release Valve to
ensure that it operates properly and does not stick.
2. Making sure the Handle Assembly is all the
way down into the Tank, turn the Handle
Assembly counterclockwise to loosen it, then
pull the Handle Assembly out of the Tank.
Figure D: handle assembly
3. Pour the liquid, through a strainer (sold
separately), into the Funnel Top.
note: Fill the Tank no higher than Max. fill line.
4. Insert the Handle Assembly all the way
down into the Tank and turn the Handle
Assembly clockwise to tighten it securely.
5. Pump the Handle to build up sufficient
pressure. Once the Sprayer is pressurized
(as indicated by increased tension on
the Handle), discontinue pumping.
6. Point the Nozzle toward the area to be sprayed,
then depress the Trigger to begin spraying.
note: Turn Nozzle to adjust spray pattern.
7. For continuous spray, press the Trigger down
and forward until it locks, then release the
Trigger. To stop continuous spray, press
down and pull back on the Trigger.
trigger
(unlocked)
trigger
(locked)
Figure E
8. As you spray, the Sprayer will depressurize.
When decreased pressure is affecting spray
pattern, pump the Handle until proper pressure
is achieved, then resume spraying.
9. To refill the Tank, pull up on the Pressure
Release Valve and remove the Handle
Assembly. Then add liquid and replace the
Handle Assembly. Pump the Handle until proper
pressure is achieved, then resume spraying.
10. When finished spraying:
• Depressurize the tank.
• Dispose of liquid.
• Clean the Sprayer according to
maintenance instructions.