Horizon Fitness H-SERIES E5 - Manual (Page 5)

BEFORE
YOU
BEGIN
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 2
GUIDERAIL CAPS
GUIDERAILS
MID-STABILIZER TUBE
SCREW (E)
MID-STABILIZER FOOT
A) Open HARDWARE BAG FOR STEP 2.
B) Slide MID-STABILIZER FEET into MID-STABILIZER TUBE and attach using 2 SCREWS (E).
D) Slide GUIDERAIL CAPS into the GUDIERAILS to seal the openings.
SCREW (E)
10 mm
Qty: 2
HARDWARE BAG FOR STEP 2 CONTENTS :
CRANK
WAVY WASHER (D)
BOLT (G) WASHER (I) WASHER (H)
FOOTPAD
LOWER LINK ARM
SCREWS (F)
PEDAL ARM
LINK ARM
WASHERS (S)
SPACER (R)
BOLT (T)
WASHER (U)
ASSEMBLY STEP
CRANK
WAVY WASHER (D)
BOLT (G) WASHER (I) WASHER (H)
FOOTPAD
LOWER LINK ARM
SCREWS (F)
PEDAL ARM
LINK ARM
WASHERS (S)
SPACER (R)
BOLT (T)
WASHER (U)
A) Open HARDWARE BAG FOR STEP 3.
B) Attach FOOTPAD to PEDAL ARM using 4 SCREWS (F).
C) Align the bracket on the RIGHT LOWER LINK ARM with the tube on the RIGHT PEDAL ARM.
D) Slide the SPACER (R) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
E) Insert 2 WASHERS (S) between the PEDAL ARM and the LINK ARM BRACKET.
F) Secure the joint with 1 FLAT WASHER (U) and 1 BOLT (T).
G) Attach PEDAL ARM to the CRANK with 1 BOLT (G), 1 WASHER (I), 1 WAVY WASHER (D) and 1 WASHER (H).
H) Repeat on other side.
SCREW (F)
12 mm
Qty: 8 BOLT (G)
13 mm
Qty: 2 BOLT (T)
15 mm
Qty: 2 SPACER (R)
70 mm
Qty: 2
WASHER (H)
Qty: 2 WASHER (U)
35 mm
Qty: 2 WASHER (S)
30 mm
Qty: 4 WASHER (I)
Qty: 2 WAVY WASHER (D)
Qty: 2
angle view
HARDWARE BAG FOR STEP CONTENTS :
H-series_E5_Rev.1.2.indd 8-9 6/16/08 2:40:08 PM