Horizon Fitness HZ SERIES EX-33 - Manual (Page 6)

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 4
������������
���������������
������������
�������������
���������������
������������
����������
�����
���
���������������������
��������������
����������������������
����������
����������
���������
ASSEMBLY STEP 3
NOTE: EX-22 Skip this step
A) Open HARDWARE BAG FOR STEP 3.
B) Attach the PERIMETER BARS using 4 BOLTS (L).
C) Attach REAR STABILIZER COVER using 2 SCREWS (M).
D) Attach FRONT STABILIZER COVERS using 2 SCREWS (M) for each side.
��������
�����
������ ���������
�����
������
HARDWARE BAG FOR STEP 3 CONTENTS :
EX-33 & EX-44 ONLY
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
C) Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are
joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET
SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
HZ EX Series Ellipticals Rev 0.4.indd 10-11 6/8/05 10:09:11 AM