Pre-operating instructions – Harbor Freight Tools 94344 User Manual
Page 9
SKU 94344
For technical questions, please call 1-800-444-3353
PAGE 9
LOCK LEVER
(13)
CYLINDRICAL
CONNECTOR
FIGURE B
PRE-OPERATING INSTRUCTIONS
WARNING! Always make sure the Engine’s Power Switch is in its “OFF”
position prior to performing any service, maintenance, or cleaning of the
Concrete Vibrator.
To Add Engine Oil:
1.
IMPORTANT! Prior to first using the Concrete Vibrator, the Engine MUST be
filled with a high quality 30W grade engine oil.
(See Engine manufacturer’s manual for complete instructions.)
2.
To do so, unscrew and remove the Engine Oil Dipstick. Pour approximately 3/4
quart of engine oil into the Dipstick Hole.
Do not overfill.
3.
Clean the Oil Dipstick. Then screw the Dipstick fully back into the Dipstick Hole.
Unscrew and remove the Oil Dipstick again, and observe the level of engine
oil on the Dipstick. The oil level should appear between the
“MINIMUM” and
“MAXIMUM” indicator marks on the Oil Dipstick.
4.
If necessary, continue adding engine oil, while rechecking the Oil Dipstick, until
the oil level reaches the
“MAXIMUM” indicator on the Oil Dipstick.
Do not exceed the “MAXIMUM” indicator mark on the Oil Dipstick.
5.
When finished adding engine oil, carefully screw the Oil Dipstick back into the
Dipstick Hole.
4.
Turn the Lock Lever (13) downward until it locks the Cylindrical Connector firmly
in place.
(See Figure B.)