Harman-Kardon AVR 247 - Manual (Page 21)

21
SPEAKER PLACEMENT
Before you begin to connect cables, it is important to place your speakers
in their correct locations in the room.
Optimally, the speakers should be placed in a circle with the listening
position at its center. The distance from the listening position to the
video display forms the radius of the circle.
The speakers should be angled so that they directly face the listening
position.
Front Speaker Placement
The center speaker is placed either on top of, below or mounted on the
wall above or below the video display screen.
The front left and right speakers are placed along the circle, about 30
degrees from the center speaker and angled toward the listener.
It is best to place the front left/right and center speakers as close to
the same height as possible, preferably at about the same height as
the listener’s ears. In any event, the center speaker should be no more
than two feet above or below the left/right speakers.
Placement of the surround speakers depends on the number of
speakers in your system. If you’re using only two speakers with the
AVR 247, place them in the front left and right positions, and skip to
the Installation section. However, Harman Kardon recommends using
the AVR 247 in a 5.1- or 7.1-channel configuration for optimal
surround sound performance.
Figure 15 – Speaker Placement (5.1-Channel System)
Placement of Surround Speakers in a 5.1-Channel
System
The side surround speakers should be placed 110 degrees from the
center speaker, that is, slightly behind and angled toward the listener.
If this isn’t feasible, place them behind the listener, with each surround
speaker facing the opposite-side front speaker. See Figure 15. The
surround speakers may be placed a little higher than the listener’s ears.
Placement of Surround Speakers in a 7.1-Channel
System
In a 7.1-channel system, the side surround speakers are placed 90 degrees
from the center speaker, directly to either side of the listening position,
which is different than in a 5.1-channel system. The surround back left
and right speakers are placed 150 degrees from the center speaker, or
directly facing the opposite-side front speaker. See Figure 16.
Figure 16 – Speaker Placement (7.1-Channel System)
NOTE: Some speaker manufacturers offer 6.1-channel speaker
systems, which are compatible with the 6.1-channel digital
surround sound formats available on DVD and elsewhere, such
as Dolby Digital EX and DTS-ES Discrete and Matrix modes.
We do not recommend using the AVR 247 in a 6.1-channel
configuration. In fact, the 6.1-channel formats will sound better
when played through a 7.1-channel system. The same surround
back channel information is played through both surround back
speakers, but with twice the power and clarity.
If you wish to use the AVR 247 with a 6.1-channel speaker
system, place the single surround back speaker directly behind
the listener, but do not connect it until after you have run the
EzSet/EQ procedure for a 5.1-channel system. After EzSet/EQ
finishes, connect the surround back speaker to the Surround Back
SPEAKER PLACEMENT
PLACEMENT DES HAUT-PARLEURS . COLOCACIÓN DE LOS ALTAVOCES
90°
150°
90°
150°
30° 30°
FL
SL SR
SBR SBL
FR
SUB
C
C
90°
150°
90°
150°
30° 30°
SUB
FR FL
SL
SBL SBR
SR
C
Alternate placement
for Side Surround
Left Speaker
Alternate placement
for Side Surround
Right Speaker
110°
150°
110°
150°
30° 30°
SUB
FR FL
SL SR
C
110°
150°
110°
150°
30° 30°
SUB
FR FL
SL
SBL SBR
SR