Hitachi 65F59A - Manual (Page 31)

·
»
»
·
³
·
»
OPERATING THE PRECODED
FUNCTION FOR YOUR VCR.
This remote is designed to operate different types of
VCRs. You must first program the remote to match the
remote system of your VCR (refer below for pre-codes).
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. To switch to VCR pre-coded mode, press and
release the VCR button.
4. Hold down the VCR button on the remote and
enter the two digit preset code that matches your
VCR, as shown below. Release the VCR button.
5. Aim the remote at the VCR and press the POWER
button. The remote will turn off your VCR when the
correct two digit preset code is entered. When this
occurs, the remote control is programmed for your
VCR. If the VCR does not turn off, try a different
two digit preset code.
6. The remote will now control your VCR.
NOTE: 1. If your VCR cannot be operated after
performing the above procedures, your
VCR’s code has not been precoded into
the remote.
2. In the unlikely event that your VCR cannot
be operated after performing the above
procedures, please consult your VCR
operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries are removed from the remote
control. After replacing the batteries
repeat the entire programming procedure
as stated above.
4. Press the Record button twice to record.
³ VCR button
This button allows the remote to control your VCR
player by setting it to VCR mode.
· PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR
codes.
» EXCLUSIVE TV Buttons
These buttons are for operating the TV.
VCR BRAND CODES
HITACHI ...................................00, 01, 02, 03, 04, 05, 06
JVC....................................................
............................13
MITSUBISHI............................................................... 16,17
PANASONIC...........................................................10, 11
SAMSUNG .............................................................14,15
ZENITH .............................................................19
SHARP ............................................................................18
SONY ...............................................................07, 08, 09
MY VCR PLAYER CODE IS: ______________________
NOTE: Refer to instruction manual of the VCR for
operation of the buttons exclusively for the
VCR.
31
The Remote Control for VCR Functions
The Remote Contr
ol
»
»
A I W A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 0
FUNAI..............................................................21
TOSHIBA......................................................12