Hitachi P50A402 - Manual (Page 13)

FIRST TIME USE
13
TV Setup Wizard
If this is the first time you have turned on your TV and the TV Setup
Wizard appears on-screen, start by selecting Yes or No in the top
portion of the TV Setup Wizard.
Use the 1. t and u CURSOR to select Yes or No and press the
SELECT button on the remote control.
Do you want the TV to find all of the channels?
Yes No
If Yes is selected proceed to step 2.
If No is selected, press the EXIT button on the remote control.
Press the 2. q CURSOR to move to the next window to select
the source.
Source: t Air u
Please connect the antenna or cable to the
input labeled “Air/Cable”.
Press the 3. u CURSOR to select Air, Cable(1) or Cable(2).
Press the 4. q CURSOR to move to the next window to start the
Auto Channel Scan.
Auto Channel Scan : Start
Press the SELECT button on the remote control to begin 5.
scanning.
Air
Scanning Channel Number : 12
Analog Digital 12-123
Scan time may take 10 to 20 minutes
Cancel
Your Hitachi Plasma television has a TV Setup Wizard feature which has the ability to help you easily setup the first time you turn on your
TV and find the channels available in your area. Please follow the instructions below.
The First time you turn on your Hitachi Plasma TV the Energy
Savings Initial Settings screen will appear. Please select either
HOME or RETAIL mode settings to advance to the TV Setup
Wizard screen. If you select HOME mode this will save energy
and is intended for home use. RETAIL mode will set the Picture
to Dynamic default Settings and the picture will be brighter. This
setting is intended for showroom and shop use. If later you want
to change the Energy Savings Initial Settings you can using the
Setup Menu (refer to page 41).
Please Select HOME or RETAIL
HOME RETAIL
HOME mode meets Energy Star™
guidelines and is best for home use.
RETAIL mode uses more energy
and is intended for in-store display.
Move SEL Select
Energy Savings Initial Settings
RETAIL Mode is intended for showroom or shop use
only, if you make adjustment changes in this mode
they will not be saved when the TV is turned Off.
The TV Setup Wizard screen automatically starts after the Energy
Savings Initial Settings Screen the first time the TV is turned on.
If you see the screen above when you turn on •
your TV for the first time and did not yet connect
your AV equipment and cables to your TV, turn off
your TV, unplug the power cord and connect your
devices and cables according to the applicable
connections in the “First Time Use” section of this
Operating Guide.
After completing the TV Setup Wizard, these •
screens will not appear again. For updating
and adding the channels available in your area
refer to the Auto Channel Scan feature on page
33.
NOTES
NOTE