Husqvarna 322R - Manual (Page 17)

English –
17
Assembling the handlebars
(322R, 323R)
ASSEMBLY
Assembling the handlebars
(325R
X
, 325R
XT
, 325RD
X
)
• Remove the screw at the
rear of the throttle handle.
• Slide on the throttle handle
on the right-hand side of
the handlebars, (see the
diagram).
• Align the hole in the
throttle handle for the
fixing screw with the hole
on the handlebars.
• Refit the screw in the rear
of the throttle handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Unscrew the bracket
components from the
handlebar bracket.
• Position the handlebars as
shown. Fit the bracket
components and tighten the
handle lightly.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it‘s attached
to the harness. Tighten the
handle.
• The handlebars can easily
be turned to fit along the
shaft for easy transportation
and storage.
• Loosen the knob. Turn the
handles clockwise so that
the throttle comes against
the engine.
• Thereafter fold the
handlebars around the
shaft. Tighten the handle.
• Attach the transport guard.
Transport position, handlebars
(325R
X
, 325R
XT
, 325RD
X
)
• Remove the screw at the
rear of the throttle
handle.
• Slide on the throttle
handle on the right-hand
side of the handlebars,
(see the diagram).
• Align the hole in the
throttle handle for the
fixing screw with the
hole on the handlebars.
• Refit the screw in the
rear of the throttle
handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Fit the bracket
components as shown in
the diagram.
• The handle mounting
must be fitted between
the arrows on the shaft.
• Loosely tighten the four
screws.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it’s
attached to the harness.
Tighten the screws.