Hitachi VT-FX6402A - Manual (Page 61)

61
3 Press the PLAY button on VCR-2. You will see the taped program being played on the TV.
4 When you see the part of the program you wish to record, press the PAUSE button on VCR-1
again to release pause and start recording.
• Press the STOP button to finish recording.
PROBLEM GUIDE / MAINTENANCE
Problem guide
No power • Make sure the VCR is plugged into an AC outlet.
Remote control doesn't
work • Make sure the batteries are fresh, and properly
installed.
Won't record • Safety tab has been removed from cassette (VCR
will
automatically eject the tape).
Won't play back • Make sure the TV/VCR switch is set to the VCR
mode.
• Make sure the TV is set to the VCR channel (3 or
4) or AUX (if
using direct audio/video hookup).
Won't make timer
recordings • The VCR power must be turned off to activate
timer recording.
• Clock is not set correctly.
• Programs entered incorrectly.
• Programs exceed the length of the cassette. Use
the EP
recording speed for maximum programming.
• Safety tab has been removed from cassette.
Snowy picture in playback • Snow or picture noise is normal during search,
still, and slow
Playback.
• Head cleaning may be required.
• Tape is worn or of inferior quality - adjust tracking
controls.
Snowy picture in normal
TV viewing • Check antenna or cable connections.
Clock shows --:-- on the
TV display • Power has been interrupted - reset the clock.
• Reset the clock.