haier HWM65TLF - Manual (Page 8)

Quick Cycle
Quick washing of the light dirt laundries only 29 minutes
Gentle Cycle
Washing the woollen textile or underwear
TEMP SELECT Button:(7)
Operating Procedure
7
SOAK
WASH
RINSE
SPIN
PROCESS
LARGE
MEDIUM
SMALL
WATER
LEVEL
WARM
COLD
TEMP
SELECT
HOT
PROCESS Button:(5)
This is to select washing process.
Soak will not work in Quick Cycles.
Water level indicator will shut off if only Spin is selected.
WATER LEVEL Button:(6)
Water levels may be set at the beginning of the wash or at
pause.
During Soak, Wash or Rinse press this button to manually
replenish water. Release to stop.
Function automatically is inactive when water
reaches the overflow protection level.
To select inlet water temperature for wash and rinse.
Initial setting is warm/cold when washer is powered on.
Press button to change selection based on clothes put
in the washer.
1.Press power on button
The washer will now be in the working status in the Normal cycle.
If the Start/pause button is not pressed with in 5 minutes after power
on the unit it will automatically switch off and return to the stand by mode.
The washer will also return to the stand by mode immediately after
completion of the wash process.
Regardless of the settings by pressing the power on/off button all
programs will stop and return to the stand by mode.
2.Selection Cycle
When the washer is powered on the Normal cycle is the default cycle.
If other cycle is required press the cycle button for desired program.
3.Process Select
Once the power is switched on the washing machine will automatically
set the Normal cycle which will Wash ,Rinse and Spin. If other selection
combinations are desired, press the process select button to choose.