haier HWM65TLF - Manual (Page 12)

Lint Filter
The lint filter must be used during washing.
It must be cleaned in time after each using.
1.Take off the lint filter.
Pull up the lint filter from the agitator.
2.Remove lint
Press the lint screen clip with your thumb and index finger, and get the screen
down ward as shown in figure below. While wet, remove the lint from the screen.
3.Install the lint filter
After cleaning, install the screen back onto the lint filter. Then put the lint filter
back in the agitator barrel.
Safety Lid Switch
If for any reason you open the lid in the middle of the wash cycle, the washer will
not spin and will shut off automatically. Once the lid is close, the washer will start
back on.
Figure 3
Agitator
Press
Lint filter
Lint Screen
Figure
Figure 2
Pull up out
Press
11