HP 2209T - Manual (Page 10)

5
Connection instructions
Installing the display
Install: Remove:
Place the display on the table (Figure 1)
Packaging procedures
If you need to package the display again, please keep the original carton and packing materials.
The procedures for re-packaging the display are as follows:
1. Unplug the power cord from the display (make sure all attached peripherals are already turned
off).
2. Put the display into the carton in the original packaging manner.
Important
Before you start, place a clean towel or cloth on a flat surface, on which you can place the removed
display panel without being damaged.
Adjusting the viewing angle
You may adjust the display's viewing angle from -5° ~ 20°.
(Figure 2)
Note:
 When you adjust the viewing angle of the display, avoid touching the LCD display with your fingers,
as this may damage or break the liquid crystal screen.
 When you adjust the angle of your display, pay attention to your adjustment action, as shown in the
figure above.