Horizon Fitness FS 50 - Manual (Page 8)

1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
&
MAINTENANCE
LIMITED
W
ARRANTY
15
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
Open HARDWARE BAG .
Remove NYLON NUT, FLAT WASHER, THREADED SCREW and BALL from end of CABLE C.
Route CABLE C through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
NOTE: After threading through one arm of RADIAL ARM ASSEMBLY thread CABLE C up
through SINGLE FLOATING PULLEY BRACKET before bringing to back through other arm.
After CABLE C routing is complete replace nylon nut, threaded screw and ball on end of
cable.
Hook HANDLES on to cable using the 2 HOOKS.
A
B
C
D
E
ASSEMBLY STEP
CABLE C
Qty: 1
HARDWARE BAG CONTENTS :
BALL
NYLON NUT
FLAT WASHER
HANDLE
HANDLE
HOOK
CLEVIS
FLAT WASHER (B)
SCREW (E)
SINGLE FLOATING
PULLEY BRACKET
CABLE C
Open HARDWARE BAG .
Remove nylon nut, threaded screw and ball from end of CABLE D.
Route CABLE D through the pulley system in the UPPER PULLEY BRACKET ASSEMBLY as
shown in diagram.
After CABLE D routing is complete replace nylon nut, threaded screw and ball on end of
cable.
A
B
C
D
ASSEMBLY STEP
CABLE D
Qty: 1
HARDWARE BAG CONTENTS :
BALL
NYLON NUT
FLAT WASHER
HOOK
CLEVIS
FLAT WASHER (B)
CABLE (D)
LAT BAR
SCREW (E)
FS 50 rev 1.0.indd 14-15 8/20/07 11:58:00 AM