Operating instructions – Harbor Freight Tools 66305 User Manual

Page 9

Page 9

SKU 66305

for technical questions, please call 1-800-444-3353.

operating inStructionS

to preVent

SeriouS injury:

do not adjust or tamper with

any control or component in a

way not specifically explained

within this manual. improper

adjustment can result in tool

failure or other serious

hazards.

Position the Lift in a safe and suitable

area as discussed above.
Press the Load Pedal (69) to fully

lower the lift.
Pull out the Ramp (1) and Pull Ramp

(8) as needed to accommodate the

length of the motorcycle.
Be sure the Front Wheel Chock (17)

is rotated toward the rear of the Lift.
Roll the motorcycle up the Ramp (1)

and onto the Deck Plate (16).

Roll the front wheel over the Front

Wheel Chock (17) and into the Wheel

Rest (21). The Front Wheel Lock will

rotate with the wheel, supporting it

from the rear.
The Wheel Chock (17) can be ad-

justed to fit your wheel. Remove the

Nut (18) from one end of the Wheel

Lock Axle (19), and slide the Axle out

of the Deck Plate (16). The Wheel

Lock can be moved as needed and

the Wheel Lock Axle inserted in the

appropriate holes in the Deck Plate.

Reinstall the Nut and tighten. See

Figure 3.
With a helper holding the motorcycle

upright, secure the motorcycle to the

Lift using the Tie Down Points (13

and 31).
Before lifting any motorcycle, it must

be securely fastened to the Lift us-

ing tie-down straps (not supplied) or

other suitable method. Two Front Tie

Down Brackets (13) and two Rear Tie

Down Brackets (31) are built into the

Lift for this purpose.
Refer to the manufacturer’s motorcy-

10.

cle service manual for recommended

attachment points on the vehicle.
There must not be hazardous ob-

11.

jects (such as utility lines or foreign

objects) nearby that will present a

hazard while working.
Before lifting the motorcycle, pull out

12.

the Safety Bar Lock Pin (40) to allow

the Safety Bar (75) to rest on the In-

ner Scissor Arm (35).
To Lift the motorcycle, pump the

13.

Pump Pedal (56) repeatedly until

the motorcycle is lifted to the desired

height.

Wheel Chock (17)

Pull Pin (7)

Wheel Lock Axle (19)

Front Wheel Rest (21)

Figure 3