beautypg.com

Save these instructions, Assembly instructions – Harbor Freight Tools 66305 User Manual

Page 5

background image

Page 5

SKU 66305

for technical questions, please call 1-800-444-3353.

Do not attempt to manually raise or

9.

lower the Lift. Operate the Lift hy-

draulically only as described in this

manual only.
Do not leave Lift unattended with a mo-

10.

torcycle on it. The Lift is not for long term

storage.
Do not leave any load on the Lift for

11.

an extended period of time. This Lift is

not designed as a storage device. Re-

move motorcycle from Lift immediately

after completing service operation.
Use only on firm, level unobstructed

12.

surface able to support the weight

of the Lift, the vehicle, and any tools

that will be located in the work area.
Do not use Lift to move the motor-

13.

cycle. This Lift is designed to lift the

motorcycle in place only.
Whenever a motorcycle is lifted, the

14.

Safety Bar (75) must be engaged

immediately before any further steps

are taken.
Do not use Lift for any aircraft purpose.

15.

For indoor use only.

16.

Do not ride on this Lift. Do not ride on

17.

the motorcycle as it is lifted. Riding

on Lift may cause personal injury.
Always control the speed of a loaded

18.

lift. It must raise or lower slowly

when loaded. Never attempt to lower

the Lift when loaded by using the

yellow No Load Pedal (71). The No

Load Pedal is only used to lower the

Lift when it is not loaded.
Do not lower the motorcycle quickly.

19.

Only use the Load Pedal (69) to

slowly lower the Lift when there is a

motorcycle on it. NEVER allow the

vehicle to drop suddenly.
The warnings and precautions dis-

20.

cussed in this manual cannot cover

all possible conditions and situations

that may occur. It must be under-

stood by the operator that common

sense and caution are factors which

cannot be built into this product, but

must be supplied by the operator.

Failure to comply with these warn-

ings may result in injury or damage to

property.

SaVe tHeSe

inStructionS.

The Lift comes completely assembled,

except for the following items: (Refer to

the exploded drawing).

tie down rings:

1.

The two front tie

downs are longer than the rear pair.

Slide the front tie downs (13) onto the

rods welded at either side of the front

end of the platform, and secure them

with bolts (14) and nuts (15). Attach

the shorter rear tie-downs (31) to the

rear rods and secure with bolts (14)

and nuts (15).

Wheel chock:

2.

Place the wheel

chock (17) on to the front end of the

platform and align it with a suitable

pair of holes. Slide the long bolt (19)

through a hole in the side of the

platform and through the sleeves

welded to the back of the chock and

out the other side of the platform.

Secure with nut (18).

front Wheel attachment.

3.

Drop the

ends of the ‘U’ shaped front wheel

aSSeMbLy inStructionS