Honeywell SERIES 2000 T7300D - Manual (Page 5)

62-0132 5
T7300D SERIES 2000 COMMERCIAL MICROELECTRONIC THERMOSTAT
Table 2. Thermostat Installer Setup Options (Continued).
Installer Setup
Number
(Press
Unoccupied
Temp key Factory-Setting
Other Choices
(Press ▲ or ▼ key to change)
Actual
Select
to change)
Display Description Display Description
Setting
Temperature
display
adjustment 37 0 No difference in
displayed temperature
and actual room
temperature89 1 thru 6 1—Display adjusts to 1°F
higher than actual room
temperature
2—Display adjusts to 2°F
higher than actual room
temperature
3—Display adjusts to 3°F
higher than actual room
temperature
4—Display adjusts to 1°F
lower than actual room
temperature
5—Display adjusts to 2°F
lower than actual room
temperature
6—Display adjusts to 3°F
lower than actual room
temperature
Minimum off
times in heating 38 4 4—4 minute minimum
off time
0, 1, 2, 3,
or 5 Minimum number of minutes
(0 thru 5) the heating
equipment will be off
between calls for heat
Installer Setup
lockout (keypad
lockout is
enabled and
disabled by DIP
switch 1 on back
of thermostat) 40 0 0—No Installer Setup
lockout
1 1—Installer Setup lockout
activated
IMPORTANT
Review the settings to confirm that they match
the system. Press Run Program to exit the
Installer Setup. Be sure to set the current day
and time immediately.
Setting Current Day and Time
1. Press Set Current Day/Time.
NOTE: On initial power up or after an extended
power loss, 1:00 pm flashes on the LCD
until a key is pressed.
2. Press Day until the current day is displayed.
NOTE: Sun=Sunday, Mon=Monday,
Tue=Tuesday, Wed=Wednesday,
Thu=Thursday, Fri=Friday, Sat=Saturday.
M4951B
Set Current
Day/Time Set Program Set Temperature Change Time/Temp Occupied Temp Unoccupied Start Time Day
System Fan
Copy
Occupied
Start Time Run Program
Temporary Occupied
Continous Unoccupied
Set Current Day/Time Clear Start Time
Unoccupied Temp
Heat/Cool Settings
Mon
PM
Set Day/Time
M4952B
Set Program Set Temperature Change Time/Temp Occupied Temp Unoccupied Start Time Day
System Fan
Copy
Occupied
Start Time Run Program
Temporary Occupied
Continous Unoccupied
Set Current Day/Time Clear Start Time
Unoccupied Temp
Heat/Cool Settings
Day
PM
Tue
Set Day/Time
3. Press increase ▲ or decrease ▼ until the current
time is displayed.
NOTE: Tapping the Set Current Day/Time will
change the time in one hour increments.
M4953B
Set Program Set Temperature Change Time/Temp Occupied Temp Unoccupied Start Time Day
System Fan
Copy
Occupied
Start Time Run Program
Temporary Occupied
Continous Unoccupied
Set Current Day/Time Clear Start Time
Unoccupied Temp
Heat/Cool Settings
PM
Tue
Set Day/Time