Horizon Fitness T74 - Manual (Page 8)

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
Open HARDWARE BAG 1.
Pull LEAD WIRE through RIGHT CONSOLE
MAST to drag upward.
Place LEFT CONSOLE MAST into upright
position. Be sure to hold the console mast
firmly, as it will not stay in the upright
position on its own.
Use BOLTS (A), 2 SPRING WASHERS (B),
and 2 FLAT WASHERS (C) to attach console
mast to the MAIN FRAME.
Repeat on the right side.
PRE-ASSEMBLY
ASSEMBLY STEP 1
A
B
C
D
E
BOLT (A)
65 mm
Qty: 4
FLAT WASHER (B)
16 mm
Qty: 4 SPRING WASHER (C)
16 mm
Qty: 4
HARDWARE BAG 1 CONTENTS :
CONSOLE MAST
FLAT WASHER
BOLT (A)
SPRING WASHER
MAIN FRAME
CONSOLE CABLE
LEAD WIRE