Harbor Freight Tools 92174 - Manual (Page 13)

Page 13 SKU 92174 For technical questions, please call 1-800-444-3353.
BROWn
BROWn
GREEn YELLOW
WIRE CLIP
WHITE (GROund)
GREEn YELLOW
WIRE FROM
sIdE RunnInG
LIGHT (A19)
WIRE FROM
sIdE RunnInG
LIGHT (A19)
BROWn
BROWn
LEFT sIdE
TRAILER FRAME
(A1)
RIGHT sIdE
TRAILER FRAME
(A1)
LEFT
TAIL LIGHT
(A15)
RIGHT
TAIL LIGHT
(A16)
FIGuRE H
To install the Wiring Harness on the Trailer, use an accessory Self Tapping Screw
to attach the White Ground Wire located at the Plug end of the Wiring Harness to
the small mounting hole in the Tow-bar (A2). (see Figure H.)
Leave about 18” of wire beyond the Hitch Coupler (A9), and run the Wiring Harness
along the inside of the Tow-bar (A2) to the front of the Trailer Frame (A1). Then, split
the
Yellow/Brown Wires from the Green/Brown Wires. (see Figure H.)
Run the Yellow/Brown Wires along the inside of the front of the Trailer Frame (A1)
to the Side Running Light (A16) located on the left/forward side of the Trailer Frame.
Then, run the
Green/Brown Wires along the inside of the front of the Trailer Frame
to the other Side Running Light located on the right/forward side of the Trailer Frame.
(see Figure H.)
Run the Green/Brown Wires to the Right Tail Light (A16). Strip the ends of the
Wires about 3/4”. Connect the Green Wire to the Red Wire of the Right Tail Light.
Then, connect the Brown Wire to the two Black Wires of the Right Tail Light.
(see Figure G.)
nOTE: It is recommended that only a qualified technician perform the electrical
service that may be needed to enable your particular make/model vehicle to power
the Trailer’s 12 volt DC lighting system.
23.
24.
25.
26.
27.