Henny Penny BCF-65 - Manual

Model BCF-24/65/110, BCM-110
2-1. INTRODUCTION This section provides the installation for the Henny Penny
Blast Chiller/Freezer.
Installation of this unit should be performed only by a
qualified service technician.
Do not puncture the unit with any objects such as
drills or screws, or component damage or electrical
shock could result.
2-2. UNPACKING The Henny Penny Blast Chiller/Freezer has been tested, inspected,
and expertly packed to ensure arrival at its destination in the best
possible condition. The rack supports are secured inside the unit
with cardboard, and the slides for the racks are packed inside the
unit. The cabinet rests on a wooden skid and is then packed inside
a heavy cardboard carton with sufficient padding to withstand
normal shipping treatment.
To avoid damage to the components, do not lay the unit
on its side. If the unit has been on its side, the unit must
be in an upright position for at least an hour before
power is applied to the unit.
Check all components for signs of being loose or dam-
aged, and make sure the system has refrigerant.
Any shipping damage should be noted in the presence of
the delivery agent and signed prior to his or her depar-
ture.
To remove the Henny Penny Blast Chiller/Freezer from the carton,
you should:
1. Carefully cut banding straps.
2. Lift the carton off the unit.
3. Lift the unit off the skid.
503 2-1
SECTION 2. INSTALLATION