Hoshizaki STACKABLE CRESCENT CUBER KM-2100SWH3 - Manual (Page 22)

22
1. Icemaker
• Icemaker water supply inlet is 1/2" female pipe thread (FPT). A minimum of 1/2" OD
copper tubing is recommended for the icemaker water supply line.
• An icemaker water supply line shut-off valve and drain valve should be installed.
• Icemaker drain outlet is 3/4" FPT. A minimum of 3/4" OD hard pipe is recommended
for the icemaker drain line. Condensation drain outlet is 3/8" OD stainless tube. The
condensation drain line can be connected to the icemaker drain line or can be run
separately.
Bin Drain Outlet 3/4" FPT
Icemaker Water Supply Line Shut-Off Valve
Icemaker Water Supply Line Drain Valve
Icemaker Water Supply Inlet 1/2" FPT
Icemaker
Drain Outlet
3/4" FPT
Condensation
Drain Outlet
3/8" OD
Stainless Tube
Bin
Icemaker
Remote Condenser Line Set Connections
Separate piping to approved drain.
Leave a 2 inch (5 cm) vertical air gap
between the end of each pipe and
the drain.
2 inch (5 cm)
air gap
Floor
Drain Fig. 16
KM-2100SRH3
Icemaker Connection