Harbor Freight Tools 91840 - Manual (Page 2)

Page For replacement parts, please call 1-800-444-3353. SKUs
91839, 91840
& 9199
Specifications
Log Capacity 5” Long, 8” Diameter Tire Air Pressure 60 PSI Cold
Overall Dimensions 79-1/4” x 4-1/” x 37-1/4” Wedge Size 7-1/8” Tall
Hydraulic Fluid Capacity .5 Gallons Toe Plate Thickness 1-5/8”
Wheel Size 8” Diameter, DOT Approved Ram Diameter 1-3/4” Overall
Model SKu 91839 SKu 91840 SKu 92199
Engine 9HP EX-27 Robin ® 9HP EX-27 Robin ® 6HP Robin ®
Cylinder Diameter 4-1/2” 5” 4.5”
Tons of Force 24 30 22
Pump Haldex ® 11 GPM, 2-Stage Gear Haldex ® 16 GPM, 2-Stage Gear Haldex ® 11 GPM, 2-Stage Gear
Weight 498 lb. 640 lb. 492 lb.
This product requires engine oil, hydraulic oil, and fuel to be added before starting.
Attempting to start the engine without oil will ruin the engine and void the warranty.
Before starting the engine, refer to the engine owners manual for additional engine
maintenance information.
Note: 8” maximum diameter applies to most soft to medium types of woods. Maximum di-
ameter of hardwoods may vary depending on density of the wood.
Note: Read and follow the instructions and safety warnings in the manual that accom-
panies the Robin® engine. Engine specifications are listed in the engine manual.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1.
Keep work area clean. Cluttered areas invite injuries.
. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted.
3. Keep children away; this unit may produce hazardous flying debris. Children must
never be allowed in the work area. Do not let them handle machines or tools.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. use the right tool for the job. Do not attempt to force a small tool or attachment to do
the work of a larger industrial tool. There are certain applications for which this tool was
designed. It will do the job better and more safely at the rate for which it was intended.
Do not modify this tool and do not use this tool for a purpose for which it was not in-
tended.
reV 07a