Hunter Fan 3 - Manual (Page 6)

6
45038-01 • 09/28/09 • Hunter Fan Company
3 • Assembling and Hanging the Fan
Steps 3-2 – 3-3
Downrod
Canopy
Canopy
Trim Ring
Upper
Glass
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
3-2. To assemble fan to hang down from a flat or angled ceiling,
insert the downrod through the canopy, canopy trim ring, and
upper glass. Feed the wires from the fan through the downrod.
3-3. Loosen the set screw on the adapter to install the pipe and
ball assembly. Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with the provided allen
wrench.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Raise the fan and place the ball into the hanger bracket.
3-5. Align the notch on the ball with the indent in the hanger
bracket. (Rotate the fan until you hear the notch pop into
place.)
Go to 4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-4 – 3-5
Indent
3 • Assembling and Hanging the Fan