Hoshizaki B-1300SS - Manual (Page 13)

13
III. Operating Instructions
See Fig. 4
A. Baffle
The baffle prevents ice in the bin from flowing out onto the floor while the bin door is open.
1. Removal
1) Rotate the back edge of the baffle up about 6 inches (15 cm).
2) Pull the baffle forward.
3) Raise the baffle up to remove.
2. Installation
1) Place the baffle into the bin through the snout. Raise the baffle up and engage the two
holes on the front edge of the baffle with the two tabs on the upper, inside lip of the
snout.
2) Lower the back edge of the baffle into position.
B. Sliding Doors
1. Removal
1) Slide the door you want to remove to the middle of the opening.
2) Raise the door up slightly. If it cannot be easily raised, slide it gently back and forth
while lifting until it raises.
3) Rotate the bottom of the door out for the front door or in for the rear door.
4) Pull the door down slightly and remove.
2. Installation
1) There is a vertical ridge on one side of each door. This ridge should face the rear on the
front door and the front on the rear door.
2) Place the top of the door into the appropriate track in the middle of the upper opening.
The top of the door should fit into three keyways.
3) Rotate and lower the bottom of the door into the track.