Hitachi VM-3700A - Manual (Page 57)

AUDIO AND VIDEO DUBBING
57
AUDIO AND VIDEO DUBBING
The audio and video dubbing feature lets you record new audio (sound) and video
(pictures) simultaneously on a previously recorded tape.
When you audio and video dub a tape, the previous audio and video are erased and
replaced with the new sound and pictures. The replacement audio and video can be the
sound and picture taken by the camera or from a video source connected to "AUDIO"
and "VIDEO" jacks on the camera/recorder.
NOTE: When dubbing the sound and picture from a video source, set "AV OUT/IN" switch
to "IN" position. When dubbing the sound and picture from the camera, set "AV OUT/IN"
switch to "OUT" and do not connect "AUDIO" and "VIDEO" jacks.
1. Insert a recorded tape. Be sure that the record safety tab is not missing.
2. Place "POWER" switch in "VIDEO" position.
3. Press "PLAY" button and then "REW" or "F.FWD" button to search to the
approximate position of the tape on which you want to dub sound and picture.
4. Press "PLAY" button again to search the exact position where you wish to stop
dubbing and then press "REC/PAUSE" button at the exact position.
5. Press "RESET" button to set the counter reading to "0:00:00".
6. Press "DISPLAY" button so counter memory "M" appears.