haier 0010557172 - Manual (Page 14)

13
Regarding the ambient
temperature display during
the heating operation
In defrosting,the indoor temperature
value displayed may be reduced due
to the dropping of cooling air of the
evaporator of indoor unit under cooling
mode. It is normal phenomenon.
Operation
HEAT Operation
Remote controller
Press TEMP. button
Every time the button is pressed, temp.setting
increase 1
o
C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
decrease 1
o
C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
3.Select temp.setting
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
LOW MED HI AUTO
4.Fan speed selection
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
5.Unit stop
Press ON/OFF button, the unit stops.
1. Unit start
Press ON/OFF on the indoor unit, or press ON/OFFon
the remote controller, unit starts.
Previous operation status appears on LCD display (no
timer and sleep).
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Then Select HEAT operation
AUTO COOL DRY FAN HEAT
Air conditioner is running under displayed wind speed
IN HEAT mode, warm air will blow out after a short period
of the time due to cold-draft prevention function.