HP FIBRE CHANNEL TO SCSI ROUTER M8201R - Manual (Page 39)

M8201R Fibre Channel to SCSI Router Installation and User’s Guide — 529971-005
6 -1
6
Hardware Replacement Procedures
This section includes:
Tape Drive and Fibre Channel to SCSI Router
Replacement
These procedures can be done for any tape drive that is connected to the Fibre
Channel to SCSI router. For information about what tape drives can be connected to a
Fibre Channel to SCSI router, see
Supported Storage Devices on page 1-3. In these
procedures the N1525A tape drive is used.
Tape Drive Replacement
1. Perform a forced reset on the tape drive in SCF by entering in the following
command:
SCF> RESET TAPE1, FORCED
2. Power off the tape drive by pressing the power switch. For the location, see
Figure 6-1 .
Tape Drive and Fibre Channel to SCSI
Router Replacement 6-1
Figure 6-1. Location of the Power Switch on the Tape Drive
Power Switch