HP P4827 User Manual
Page 13
l1725.fm Page 12 Friday, March 1, 2002 1:11 AM
1
hp L1725 LCD Monitor
Setting Up the Monitor
To connect the cables to the monitor:
1 Make sure the computer is turned off.
2 Plug the video cable into the correct video connector (VGA or
DVI-D) on the back of the monitor. Secure the cable by tightening
the thumbscrews.
VGA cable
→
VGA connector
DVI-D cable
→
DVI-D connector
NOTE:
All monitors are equipped with both a VGA and a DVI-D
connector and come with a VGA cable. Using both video
connectors, you can connect this monitor to up to two
computers at the same time.
3 Open the cable management door and secure the video cable in
the cable clips provided, making sure that the cable length is
sufficient for the mode in which you will use your monitor
(landscape or portrait). Refer to
in the picture on the previous page.
NOTE:
To change your monitor’s position or mode easily, make
sure that the length of your video cable between points a
and b is:
at least 480 mm in portrait mode
at least 440 mm in landscape mode.
4 Route the video cable, using the cable management at the
monitor’s base, and plug it into the corresponding video connector
on the computer.
12 English