Harbor Freight Tools Angle Drill With Keyless Chuck 92188 - Manual (Page 3)

SKU 92188 For technical questions, please call 1-800-444-3353. Page 3
Assembling and Operating the Angle Drill
Unplug the electric drill or disconnect the air hose on the air powered drill before attempting to attach 1.
the Angle Drill. The drill used to power the Angle Drill should also be turned OFF.
Insert the Shaft (#13) of the Angle Drill into the chuck of the drill being used to power this attachment. 2.
Properly align and tighten the Shaft in place (read instructions provided with the drill being used to
power this attachment).
Insert the bit of choice into the Chuck Casing (#12) of the Angle Drill and tighten in place (the chuck is 3.
keyless).
Properly grip the Drill/Angle Drill Attachment. One hand will operate the power drill and the other 4.
hand will wraparound the Spindle Case (#2) of the Angle Drill attachment, to support the tool while it
is being used.
Before using the Angle Drill on the workpiece, turn on the drill and test its operation. Make sure the 5.
Angle Drill is properly aligned for maximum leverage. Check that the drill bit is properly inserted.
The Angle Drill is now ready to be used. Align the drill bit on the workpiece. While firmly holding the 6.
power drill and the Angle Drill, turn on the power drill and begin drilling.
Caution: Always unplug the power drill or disconnect the air hose on air powered drills, before
changing bits or making adjustments to the Angle Drill.
Parts List
# Description Qty
1 Needle Bearing 1
2 Spindle Case 1
3 Clutch Pin 1
4 Ball Bearing 2
5 Bevel Gear 1
6 Ball Bearing 1
7 Angle Head 1
8 Key 1
9 Bevel Gear 1
10 Bearing Cap 1
11 Chuck Casing 1
12 Chuck Screw 1
13 Shaft 1
Note: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.