Henny Penny BCM-110 - Manual (Page 6)

Model BCF-24/65/110, BCM-110
1-3. TROUBLESHOOTING
(Continued)
Problem Cause Correction
The evaporator is iced-up Faulty de-icing heater Replace de-icing heater
after a De-icing Cycle
Evaporator temperature at end Increase the setting of step 8, in
of De-icing Cycle too low Programming Section of
Operator’s Manual
Maximum time of De-icing Cycle Increase the setting of step 7, in
too short Programming Section of
Operator’s Manual
Too much water on evaporator The unit has been shut down without Start a De-icing Cycle
fins a De-icing Cycle
Slow to decrease Compressor not working properly Check compressor and re-
in temperature (decline in place if necessary
performance)
Evaporator fan not working properly Check the fan and replace if
necessary
Temperature of room too high Ventilate the room
Not enough clearance around unit Relocate the unit; see Location
Section of the Operator’s
Manual
1-2 603