Epson CX4400 - Manual (Page 9)

Epson Stylus CX4400 Series
5/07 9
1. Make sure the CX4400 Series is on and the red B ink light is
on but not flashing.
2. Open the scanner and make sure its support locks in place.
Caution:
Do not touch any area shown below.
3. Press the y Stop button. The print head moves to the _
position to indicate which cartridge is low or expended.
Note:
Do not move the print head by hand; this may damage the
CX4400 Always press and release the
y Stop button to move it.
4. Press the y Stop button again.
❏ If another cartridge is low or expended, it moves to the
_ position. Press the y Stop button again to see if
more cartridges are low or expended.
❏ If no other cartridges are low or expended, the print
head moves to the replacement position.
5. Open the cartridge cover.
6. Squeeze the tab on the cartridge and lift it straight out.
Dispose of it carefully. Do not take the used cartridge apart
or try to refill it.
Warning:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets into your eyes, flush them immediately with
water. Keep ink cartridges out of the reach of children.