beautypg.com

Cleaning the blade brake clutch shield, Blade brake clutch units only), Cleaning under the cover plate – Exmark Commercial 21 4500-686 Rev. B User Manual

Page 33: Non-blade brake clutch units only), Maintenance

background image

Maintenance

2. Disconnect the wire from the spark plug (see

Figure 10 and Figure 11).

3. Pull upward on the back of the cover to unsnap

the front and back cover tabs (see Figure 32).

4. Lift off the cover and brush out all the debris

around the belt area.

5. Install the belt cover by pushing down on the rear

first and then snapping the front onto the mower
housing.

6. Connect the wire to the spark plug.

Cleaning the Blade
Brake Clutch Shield
(Blade Brake Clutch Units
Only)

Service Interval: Every 50 hours

1. Stop the engine and wait for all moving parts to

stop.

2. Disconnect the wire from the spark plug (see

Figure 10 and Figure 11).

3. Drain the gasoline from the fuel tank. Refer to

Emptying the Fuel Tank and Cleaning the
Fuel Filter
section.

4. Tip the lawn mower onto its right side (air filter

up).

5. Remove the blade nuts and the blade (see

Figure 25).

Figure 36

1.

Screws

2.

BBC Shield

6. Remove the three screws holding the BBC shield

onto the unit (see Figure 36).

7. Remove the BBC shield and brush or blow all

the debris from under the shield and around the
BBC system.

8. Install the BBC shield. Tighten the screws to

secure the BBC shield to the deck.

9. Install the blade and the two blade nuts.

10. Turn the lawn mower upright.

11. Connect the wire to the spark plug.

Cleaning Under the Cover
Plate (Non-Blade Brake
Clutch Units Only)

Service Interval: Every 50 hours

1. Stop the engine and wait for all moving parts to

stop.

2. Disconnect the wire from the spark plug (see

Figure 10 and Figure 11).

3. Drain the gasoline from the fuel tank. Refer to

Emptying the Fuel Tank and Cleaning the
Fuel Filter
section.

4. Tip the lawn mower onto its right side (air filter

up).

5. Remove the blade bolt, blade support, and the

blade (see Figure 25).

Figure 37

1.

Blade bolt

4.

Cover plate

2.

Blade support

5.

Screw

3.

Blade

6. Remove the three screws holding the cover plate

onto the unit (see Figure 37).

7. Remove the cover plate and brush or blow all the

debris from under the plate.

33