Epson 811p - Manual (Page 71)

Maintaining and Transporting the Projector 65
Follow these steps to replace the lamp:
1. Turn off the projector, wait for it to cool down (when the light
stops flashing), then unplug the power cord.
2. Allow the projector to cool for at least half an hour (if it has been
on).
3. Use a screwdriver to slide the latch and pop open the lamp cover.
Then lift up and remove it.
4. Use a screwdriver to loosen the two silver screws holding the lamp
in place. (You can’t remove these screws.)
warning
Let the lamp cool before
replacing it. If the lamp
breaks, handle the shards
carefully to avoid injury.
600-811-820.book Page 65 Tuesday, April 30, 2002 10:17 AM