Eiki EIP-1 - Manual (Page 27)

26
7. Appendix
7.1 Common problems and trouble-shooting
If you are having a problem with your projector, please check the following:
If you still cannot solve the problem, please contact your local distributor or our
service center.
Q.: No image on the screen at all?
Make sure that you have properly connected the video enhanced adapter and
the relevant cables mentioned in previous chapters.
Make sure the plug is not bended or broken.
Please check if the lamp has been installed properly.
Please check if you have removed the lens cap and turned on the projector.
Q.: Incorrect resolution?
Please check if the video card of your computer has been set at a resolution
less than 1280 X 1024.
Q.: Unsteady or flickering image
Press the Auto key of the remote controller or the Auto/Enter key of the
projector.
Or use Phase on the Display menu to correct the problem.
You can also change the color setup of the display card on your computer.
Q.: Vertical flickering stripes on the image
Press the Auto key of the remote controller or the Auto/Enter key of the
projector.
You can also use Frequency on the Display menu to adjust the stripes.
Or re-set the display mode of your display card; and make it compatible with
the projector.