Electrolux Ventilation Hood - Manual (Page 15)

15
To Level the Cooker Hood
1. Remove the lower grille by pressing inwardly
on the two slide catches located towards either
side of the grille towards the front. The grille
will open from the front.
2. Slide the right edge of the grille forward until it
clears the guide and then unhook the left hinge
pin.
3. Support the grille when removing it from the
guides carefully.
4. The two levelling screws will be visible towards
either end of the back panel.
5. Turn the screws clockwise to lift the front edge
of the hood and use a spirit level to check the
hood is positioned at right angles to the wall
before fitting the security system.
6. The wall brackets have two studs and when
the cooker hood is hung onto the brackets the
studs project through the holes above the
levelling screws.
7. When the hood is level fit the two shake proof
washers and nuts supplied to fully secure the
cooker hood.