Exabyte 1005911-003 - Manual (Page 11)

March 2002 Page 11 of 12
7 Testing the library and resuming operation
11. Press [ENTER] and use the arrow keys to select SCSI mode. Press [ENTER]
again.
If the library does not operate correctly, check the following:
If you cannot solve the problem yourself, contact your service provider or
Exabyte Technical Support (1-800-445-7736 or 1-303-417-7792).
SCSI library Fibre Channel library
#
Are the devices on each SCSI bus attached to
the library all LVD?
#
Are the SCSI buses terminated?
# Are the SCSI cables firmly connected to the
library, tape drives, and host computer?
# Are the SCSI IDs unique for the devices on each
SCSI bus?
# Is the library operating in the correct control
mode? (For most applications, the control
mode should be set to SCSI.)
#
Are the GBICs and cables used to connect the
tape drives to the Fibre Channel loop
compatible?
# Are the Fibre Channel cables firmly connected
to the library, tape drives, and the Fibre Channel
hub or switch?
# Is the library operating in the correct control
mode? (For most applications, the control
mode should be set to SCSI.)