Extreme Networks ALTITUDE 4700 - Manual (Page 57)

Altitude 4700 Series Access Point Installation Guide 57
Radio Frequency Interference Requirements – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Devices using the 5.470 – 5.725 GHz band shall not be capable of transmitting in the
band 5.60-5.65 GHz in Canada, make sure that Canada is the country selected during
setup to ensure compliance.
Radio Transmitters
This device complies with RSS 210 of Industry & Science Canada. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that permitted for successful communication.
This device has been designed to operate with the antennas listed in this guide, and
having a maximum gain of 13.9 dBi (2.4 GHz) and 13 dBi (5 GHz) for radios one and
two. Antennas not included in this list, or having a gain greater than 13.9 dBi (2.4 GHz)
and 13 dBi (5 GHz) for radios one and two, are prohibited for use with this device. This
device has been designed to operate with the antennas listed in this guide, and having a
maximum gain of 3.03 dBi (2.4 GHz) and 4.06 dBi (5 GHz) for radio three. Antennas not
included in this list, or having a gain greater than 3.03 dBi (2.4 GHz) and 4.06 dBi (5
GHz) for radio three, are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
Label Marking: The Term "IC:" before the radio certification signifies that Industry
Canada technical specifications were met.
CE Marking and European Economic Area
(EEA)
The use of 2.4GHz RLANs, for use through the EEA, have the following restrictions: