EverFocus ED610 User Manual

Page 16

Text mode
Original mode

- 15 -

Step 2 Open the dome cover and place the Focus aiding lens cap on the lens, making sure that the
cap’s notch is resting on the zoom knob.

Step 3 With cap on, adjust the focus and zoom rings by loosening the knobs and turning the rings
until subject is in focus. Retighten the knobs when done.

Step 4 When finished adjusting focus and zoom, remove the focus aiding cap from the camera lens,
replace the dome cover and secure the cover by turning it clockwise. See Section 2.2.4 below for
additional information.

NOTE: It is recommended to put the desiccant pack under the bracket. Or, use a cable tie to secure it
before placing the cover back on the camera.