Electrolux ZDF 501 - Manual (Page 20)

20
Something not working
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested corrective actions.
Fault code / malfunction Possible cause Solution
The dishwasher does not fill with
water.
- continuous flashing of the
light of the running programme
- appears in the digital
display
The dishwasher will not drain.
- continuous flashing of the
light of the running programme
- appears in the digital
display
The water tap is blocked Clean the water tap.
or furred with limescale.
The water tap is turned off. Turn the water tap on.
The filter (where present) Clean the filter in the.
in the threaded hose fitting at threaded hose fitting.
the water inlet valve is blocked.
The water inlet hose has Check the water inlet hose
not been correctly laid or it is connection.
bent or squashed.
The sink spigot is blocked. Clean out the sink spigot.
The water drain hose has Check the water drain hose
not been correctly laid or it is connection.
bent or squashed.
- continuous flashing of the
light of the running programme
- appears in the digital
display
Anti-flood device is activated. Close the water tap and contact
your local Service Force Centre.
The programme does not start.
The dishwasher door has Close the door
not been properly closed.
The main plug is not plugged in. Insert the mains plug
The fuse has blown in the Replace the fuse.
household fuse box.
Delay start has been selected If dishes are to be washed
immediately, cancel the delay
start.
Once these checks have been carried out; close the dishwasher’s door and switch on the
appliance. Press the button of the programme that was running before the intervention of the
alarm. The programme will continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your Service Force Centre.
156999 58/0en 27-03-2006 15:15 Pagina 20