Electrolux EWX 14450 W - Manual (Page 40)

40 electrolux installation
If you intend to drain the hose from the
machine into a sink, make sure that the
sink is empty and the plug hole is not
blocked. Use the plastic “U -Piece”
supplied.
Important!
Before installing the machine to new
pipework or to pipework that has not
been used for some time, run off a rea-
sonable amount of water to flush out
any debris that may have collected in
the pipes.
Special conditions
If the floor is carpeted or covered with
crumbly or soft material, insert a rigid
support base under the feet to prevent
noise, vibration or displacement. The
base should protrude a few
centimetres beyond the edges of the
machine.
Warning !
The machine should NOT be placed on
deep pile carpeting.
Note
Please ensure that when the appliance
P1198
Loop
is installed it is easily accessible for the
engineer in the event of a breakdown.
In the interest of the environment
Washer-dryers should be connected to
the FOUL drainage system, the water
will then be taken to a sewage works
for treatment before being discharged
safely into a river.
It is essential that these appliances are
not connected to the surface water
drainage system as this water is dis-
charged directly into a river or stream
and may cause pollution.
If you require any further advice please
contact your local water authority.
SHOWER
BATH
SINK TOILET
BIDET
WASHING
MACHINE DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
P0987
TREATED
DISCHARGE
132962470.qxd 11/08/2008 11.20 Page 40