Eagle Electronics Cuda 128 Portable - Manual (Page 25)

21
Bracket Installation
Mount the unit in any convenient location, provided there is clearance
when it’s tilted for the best viewing angle. You should also make sure
there is enough room behind the unit to attach the power/transducer
cable. (See the following drawings, which show the dimensions of a
gimbal-mounted Cuda 168EX sonar unit and a Cuda 128 or 168.)
Holes in the bracket’s base allow wood screw or through-bolt mounting.
You may need to place a piece of plywood on the back side of thin
panels to reinforce the panel and secure the mounting hardware.
Front view (left) and side view (right) showing dimensions of Cuda
168EX when mounted on gimbal bracket.
Drill a 5/8" (15.9 mm) hole in the dash for the power/transducer cable.
The best location for this hole is immediately under the gimbal bracket
137.9
[5.43]
Millimeter
[Inch]
173.9
[6.85]
157.9
[6.22]
56.9
[2.24]
23.4
[0.92]
72.9
[2.87]