Extron electronic P/N 68-424-02 User Manual

Page 5

Extron • System 4

Switcher Series • User’s Manual • P/N 68-424-02 Rev. D

Configuration and Connections

Epson Installation

Page 5

6. Connect the Epson Comm Adapter’s 9-pin female connector to the 9-pin male

connector of the projector cable. Connect the other end of the Comm Adapter to
the Communications Extension cable (CC-50’ or CC-100’).

7. Plug the 15-pin HD connector of the Communications Extension cable into the

PJ Comm port on the System 4

______ Secure all of the connector screws.

8. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV

cable onto the System 4

output and those on the other end onto the matching

BNCs on the Epson 8000/7250 connector panel.

9. Power on the System 4

and the projector.

10. Press the projector’s Menu button. From the projector display, select Options

and enter this selection.

11. Select Mouse/Com 1, then select BNC Format RGB and enter this selection.

_ When the projector and switcher are communicating with each other, there will be a delay of

30 to 60 seconds when powering the projector on/off using the System 4

. While waiting for

the projector to power on, the message “ Pls Wait PRJ Dwn” will display on the System 4

’s LCD.

System 4

Series – Epson 8000/7250 Projector Connections

Use the illustration below as a guide when connecting the System 4

to an

Epson 8000/7250 projector. Refer to Epson documentation to continue the
installation.

____________ In a rack mount, do NOT allow the weight of the cables to be supported by the

System 4

. See page 2-5 for cabling guidelines.

9-Pin

Comm Adapter

26-484-01

"I"

CC 50'

3, 4 or 5 BNC

15-Pin

9-Pin

"I"