Extron electronic P/N 68-424-02 User Manual

Page 4

Extron • System 4

Switcher Series • User’s Manual • P/N 68-424-02 Rev. D

Epson Installation

Configuration and Connections

Page 4

(Note: Information depends on
System 4

setup.)

(See note.)

[System 4

model and software

version displayed here]

Connecting System 4

to Epson 8000/7250

If the System 4

is already configured for an Epson 8000/7250 projector, go to

step 4. If it is not set up correctly, it will be necessary to change switch settings
on the System 4

’s Main Controller Board. Begin at Step 1 to verify the correct

configuration.

1. Use the Front Panel to display the Information Menu to verify that the System 4

is already set up for the Epson 8000/7250 projector. Apply power to the
System 4

and do the following:

a. Press

to display the M

ENU

ELECT

on the LCD screen.

b. Press

to step to Menu 8.

c. Press

to select this menu.

d. Press

to display the configuration. The example to the left is general,

yours will show the System 4

model name, the software version and the

following information:
PRJ = EPSON
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)

2. Go to the procedure on page 2-3 of the

System 4

User’s Manual to remove the

System 4

cover. Then go to page 2-4 and refer to the configuration below to

set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.

Config

Projector

SW1: 1-2-3-4 SW2

SW3

SW4

SW5

SW6

Prj Cable

Comm

Adapter

Epson 8000/7250

off-on-off-on

J15

26-484-01

3. Double-check your work and be sure the System 4

cover is on securely.

4. Install the System 4

in its place of operation (i.e. rack), but not powered on.

__________ Changes in some switch configurations are not detected until the power is

removed at the AC cord, and then restored.

Refer to the following connection diagram and continue.

5. Connect the projector’s Comm cable (as shown) to the Com 1 DIN connector of

the Epson projector.

}