Summit 43 Inch Island Gas Cooktop Instruction Manual - Manual (Page 8)

7
Gas Connection
Natural Gas and Propane Gas
Natural gas installations require the connection of a gas regulator to the
cooktop. You will find this regulator among the accessories supplied with the
appliance.
Assemble the regulator (noting the direction of gas flow) and transition pieces
(supplied) in accordance with the figure below.
The maximum gas supply
pressure (in accordance with the
inlet pressure rating of the
pressure regulator supplied).
The gas supply pressure for
testing the regulator setting the
pressure shall be at least 1 in.
water column (249 Pa) above the
specified manifold pressure).
The transition piece on the supply side of the regulator must be provided by
the installer. Unions compatible with the hose fittings must be used and
connections tested for gas leaks.
Be sure that the supply connection point is accessible with the appliance
installed.
WARNING: Be sure the hose assembly is restrained from accidental contact
with the flue or flue outlet of an under-counter oven.
Electrical Connection
The electrical connections of the appliance must be carried out in compliance
with local standards and provisions.
Before connecting the appliance, check that:
1. The electrical capacity of the main electrical supply and current sockets suit
the maximum power rating of the appliance. (See the data label attached
to the bottom of the cooktop.)
2. The socket or system has an efficient ground connection in compliance
with local standards and provisions. The manufacturer is not responsible
for failure to comply with these provisions.